In the kitchen renovation, the installation of cabinets is a very important part. If the installation is not good, no matter how good the cabinet is, it will not be easy to use. The quality of the cabinets can be seen when purchasing. Good plates and hardware are required by the manufacturers to issue quality inspection certificates. Can be installed but there is no certificate as a standard for inspection, but I don't understand at the scene. How can I know the quality of the project? With everyone's questions, the reporter interviewed two experts in related industries and asked them to tell us what to do.
Faraday cabinets
External inspection is firm and tight
Relatively speaking, the general appearance of good or bad is relatively good judgment. However, some specific data are not what most people know. In general, judging the suitability of a set of cabinet installations mainly depends on two aspects, namely the edges and seams. Edges include: cabinet edge, door edge, and table edge; seams include: cabinet joints, door joints, countertops and cabinet joints, countertops and wall joints, and countertops and cookers, sinks and Other joints .
Instructing experts:
Only from the external inspection of a set of cabinets can be tested from five aspects.
Look at the appearance. Good cabinet installation must first strictly follow the requirements of the drawings and must not change position; secondly, the external appearance of the cabinet should be kept in the original state with no scars; then the cabinets and cabinets should be kept horizontal; the door panel and the drawer surface should be divided up and down, front and back, and left and right. Also be consistent.
Second, look at the data. The allowable error degree of cabinet installation should be less than or equal to 2mm; the distance between the left and right sides of the cabinet body and the wall surface is less than or equal to 10mm; the stove cabinet installation should be aligned with the range hood, the allowable tolerance is ±20mm; the door and the cabinet body, the door and the The relative position difference between adjacent surfaces of the door, drawers and cabinets, drawers and doors, drawers and drawers shall be less than or equal to 2mm; cabinet cabinets shall be used to fasten adjacent cabinets, cabinets and cabinets. The misalignment and surface misalignment tolerance between the cabinet and the cabinet is less than or equal to 1mm.
Three look firm. Firstly, the wall cabinet and the wall should be firmly connected, and the connecting screw ≥M8. Each 900mm length must be connected with two or more fixing points to ensure that the load-bearing requirements are met; the connection between the mounting parts of the next spliced ​​structure cabinet should be firm and secure, and the fastening screw must not be loosened. All should be tightened; there should be a level hood installation, which should be firmly fixed to the wall or the connecting plate, and should not be loosened or shaken. There must also be a firm connection between the table top and the cabinet, and must not be loosened.
Four to see the safety performance. Safety is very important. Therefore, all drawers and baskets should be easy to pull, no block, and limited protection devices to prevent direct extraction; there are all exposed sharp corners of the cabinet must be dulled, metal parts in the touchable position to be sanded, No burrs and sharp corners are allowed.
Five look clean. The formal installation site should pay attention to civilized construction. Before the construction, clean the site and remove the debris. During the construction, we must also pay attention to the protection of the product and the site. Clean up the garbage in time, and must not allow the sawdust and smoke to fly. We must not open the customer's range hood to extract the smoke. After the final installation, you must Clean up the sawdust and dust in the cabinet, then clean the cabinet body and table top, and finally clean the site, collect the packaging and the garbage left after the construction, and take it away.
Metal plate hoods Formaldehyde Drawers Cabinets Doors Cabinets Doors Cabinets Kitchen Doors
Mirror surface (U-Groove) / Laminate Flooring
Hongda Anxin Decorative Material Co., Ltd. , http://www.hb-flooring.com