I. Hydropower
1, waterproof construction should use waterproof coating
2. Waterproofing works should be done after the hidden construction is completed and accepted
3, after the completion of waterproof construction to do two water storage test
4, the bathroom waterproof layer should not be less than 1.8cm
5, floor drain, Yang angle, pipelines and other places to do more waterproof engineering
6, floor drain to use deodorant floor drain
7, hot and cold water left hot right cold
8, try not to walk from the ground
9, cold water pipe in the wall table to have a protective layer of 1cm, hot water pipe is 1.5cm, so the slot to open deep
10, install the PPR pipe to consider the thickness of the tiles attached so that the pipe will not be exposed
11, cooking only a few minutes, washing vegetables for a long time, the water gate must buy a big
12, leading and countertops to support, if not fix it can not be installed
13, toilet installation can not use cement, use silicone
14, toilets, taps should be carefully protected after installation
15, to consider the toilet pit when buying a toilet
16, the washing machine to consider whether it is drainage or drainage
17, best not to install the bathroom phone, easy to damp
18, the bathroom mirror must first consider the size, otherwise the mirror headlights are easy to install high
19, bathroom pipe is best to leave the access hole
20, weak electricity can not be installed in a pipe
21, left zero, right phase grounded
22, power socket 30cm from the ground, switch 140cm
23, switch not installed behind the door
24, a lot of sockets should be good
25, high-power electrical appliances with 16A sockets, such as air conditioning
26, the cassette should be used well
27, cassette must be matched with the panel, otherwise it may not be installed
28. The cross-sectional area of ​​the wires in the PVC wire conduit must not exceed 40% of the cross-sectional area of ​​the wire conduit
29, bedroom air conditioning do not face the bed
30, air conditioning hole to consider outward tilt, otherwise the rain will come in
31, lights try to consider dual control
32, the best bathroom to install splash socket
33, on the balcony to consider installing the socket
34, wire troughs should be horizontally and vertically arranged, easy to use later
35, public flue to install the reverse valve
36. The bought electrical appliance must allow workers to read the manual
37. Instructions and warranty cards must be kept
Second, Mason
38, cement can not be used beyond the factory period of three months
39. Different types and grades of cement cannot be mixed
40, sand must use river sand, taste with the mouth to know
41. Wall tiles should be soaked in water for more than two hours.
42, wall tiles would rather buy a few more, do not buy less, otherwise it is prone to color
43. There cannot be two rows of non-complete bricks on a wall
44. Clean the tiles immediately after completing the insertion
45, the ground paste marble (light color), the back of the stone to do waterproof
46. ​​To cut a 45-degree angle at the corner of the sun
47, floor tiles to be inclined to drain, otherwise easy to collect water
48, wall tiles hit the pipe mouth to use the cut form, so it looks like a whole piece of brick
49, ground marble should be dry shop
50, floor tiles must be dirty, non-slip, do not just look good
51, matt tiles difficult to clean
52, balcony floor tiles should pay attention to drainage direction
Third, carpentry
53, the best use of dried larch keel
54. After the big wooden plate is bought, it must be sawn and dried.
55. The woodwork enters the arena to play the horizontal line of the house first
56, you must buy a paint brush to prevent it from being stained.
57, ceiling fan can not be installed on the ceiling keel
58, when the color panel construction must be pre-selected
59, suspended ceiling of the ceiling shall not be greater than 300mm from the wall
60. The gypsum board should be fixed with a countersunk head tapping screw, enter the board surface 1~2mm, and do rust treatment, can not use the gun nail
61, the distance between the plasterboard nails shall not be greater than 200mm
62, gypsum board and wall have 3mm seams for crack prevention
63, gypsum board is best done at the sun corner protection
64. Paint the paint on the top and bottom of the wooden door
65, the bottom of the bathroom door cover to brush waterproof
66. The size of the door should be the same
67, furniture as far as possible not to let the carpentry do, do not do well
68, cabinet as much as possible to buy the whole, woodworking is not good, the design is not OK
69, various sizes must be considered well, it is too much trouble
70, do not do the dark track to do their own move the door, after no way to repair
71. When the bathroom is small, try to do the sliding door, do not open the door, occupy the place
72. Uncertain woodwork must be communicated with the foreman. Do not let them make their own claim.
73. Money is the hard truth in your hand
74, children at home, less glass
75. Make sure the workers have a good look at the drawings
76, kitchen drawer is very useful
77, floor wood keel flatness is 5mm
78, wool floor to be laid 30 degrees or 45 degrees, between the board and the board to stay 2 ~ 3mm, stitches should be staggered
79, to leave 8 ~ 10mm seam between the floor and the wall
80. Expansion joints should be considered when the length of the composite floor exceeds 8m
81. Minimize the use of MDF as a door cover
82. The hinges and hardware must be used well
83. The Yuba should be mounted on wooden keels. It cannot be mounted directly on the suspended ceiling.
Fourth, paint
84, medium and dark latex paint construction do not mix with water, otherwise it is prone to color
85, Plasterboard joints to be bandages
86. It is better to have a cool cloth on the wall where there is a gap.
87, some putty on the original wall is best to get rid of, or brush again glue seal
88, try to buy a well-known brand of paint, decoration company recommended or foreman recommended not try to use
89, the weather is too wet, do not paint paint
90, paint, paint grinding to be completely dry
91. The next paint must be done after the previous paint is dry
92, metal surface paint to do rust treatment
93. The weather is too cold and the quality of paint construction will be poor
94. When the door is painted, use a textured paper to cover the hinge and the door lock
95, too hot, pay attention to ventilation
96. Apply oil on the wall when applying wallpaper
97. When you are wallpapering, you must remove the panel of switch and socket
98, light, mercerized latex paint to be completed once, make up for color differences
99. After the baseboard is installed, use putty and latex paint to make up the seam.
100. Frosted glass should be protected with newspapers
Renovation experience Lacquer Sockets Toilets Lacquer paints Switch fittings Fittings for companies Decorating companies Glass bricks Drawers Cabinets Doors Ceiling fans Lamps Marble Tiles Mirrors Front lamps Glass sliding doors Glass furniture Marble Cabinets Kitchen wall tiles Doors Flooring tiles Kitchen cabinet doors Glass doors Kitchen glass Sliding door Bathrooms Tiles Bathroom Doors Bathrooms Wall tiles Bathrooms Doors Dimensions Bathroom Dimensions Bathroom Ceilings Whole Bathrooms Toilets Designs Toilets Waterproof Toilet Tiles Bathroom Sliding Door Tiles Tiles Kitchen Tiles Balcony Tiles Small Bedrooms Floor Tiles Bedroom Lamps
Portable Generators are useful when temporary or remote electric power is needed, but they can be hazardous. The primary hazards to avoid when using them are carbon monoxide poisoning, electric shock or electrocution, and fire.
We would like you to know that there are simple steps you can take to prevent the loss of life and property resulting from improper use of Portable GeneratorsTo Avoid Carbon Monoxide Hazards:
1. Always use generators outdoors, away from doors, windows and vents.
2. NEVER use generators in homes, garages, basements, crawl spaces, or other enclosed or partially enclosed areas, even with ventilation.
3. Follow manufacturer's instructions.
4. Install battery-operated or plug-in (with battery backup) carbon monoxide (CO) alarms in your home, following manufacturer's instructions.
5. Test CO alarms often and replace batteries when needed.
To Avoid Electrical Hazards:
1. Keep the generator dry. Operate on a dry surface under an open, canopy- like structure.
2. Dry your hands before touching the generator.
3. Plug appliances directly into generator or use a heavy-duty
outdoor- rated extension cord. Make sure the entire extension cord is
free of cuts or tears and the plug has all 3 prongs, especially a
grounding pin.
4. NEVER plug the generator into a wall outlet. This practice,
known as backfeeding, can cause an electrocution risk to utility workers
and others served by the same utility transformer.
5. If necessary to connect generator to house wiring to power
appliances, have a qualified electrician install appropriate equipment.
Or, your utility company may be able to install an appropriate transfer
switch.
To Avoid Fire Hazards:
1. Before refueling the generator, turn it off and let it cool. Fuel spilled on hot engine parts could ignite.
2. Always store fuel outside of living areas in properly labeled, non-glass containers.
3. Store fuel away from any fuel-burning appliance.
Portable Generators
Portable Generators, Portable Gasoline Generators, Generators Suppliers, Portable Electric Generators, Mini Portable Generators
Zhejiang Taizhou Wangye Power Co., Ltd , http://www.wyengine.com