ã€China Aluminum Network】 1. Check all parts of machinery and electrical equipment before driving to check whether the connecting bolts are loose; whether lubrication points are normal, whether the transmission device is normal and reliable, the protective device is in good condition, whether the electrical instrument is sensitive, the motor carbon brush Good contact. 2. After the vehicle has been parked for one week, inspect the rotating parts of the equipment or have obstacles around it and remove it. Stations are not allowed around the start. 3. After checking, press the start button to start the motor and pay attention to the current change. Aluminium powder ball mill shall not be started more than twice in a row, and it shall be separated by more than 5 minutes between the previous and the second time. If it is started for the third time, it must be checked with an electrician and fitter before starting. Do not start with other equipment. Start with staggered to avoid tripping. 4, after the normal operation of aluminum grinding ball machine, we must strictly according to the provisions of water supply, ore, add steel ball, prohibit overload operation, idling time does not exceed 15 minutes, so as not to break the liner. 5, the operation should pay attention to check whether the cylinder leakage of the slurry, carefully observe the current, voltage, feed, feed water is normal, check the motor and spindle temperature every half an hour is not greater than 60 ° С, found that problems in a timely manner. 6, the operation should pay attention to observe whether the hollow shaft, the oil ring is rotated with oil, the temperature of the hollow shaft is normal, such as the discovery of hollow shaft heating, close to burning tile, should immediately take forced cooling measures, not immediately stop, so as not to cause "hold shaft ". At the same time pay attention to check the amount of oil lubrication, temperature, timing oil. 7. The aluminum powder ball mill should stop feeding before stopping. After the concentrate is processed in the standby, stop the water supply. Press the parking button and pull the switch.