Pumps in the use of the process must be carried out routine maintenance, if there is a failure, it should be repaired in order to allow the normal operation of the pump, and now to introduce the basic method of water pump maintenance. The basic method of pump maintenance A minor repair pump 1, mechanical seal: replacement, cleaning. 2, check the bearings and oil chamber, replace the transformer oil. 3, to eliminate the defects and leaks found in operation, check and tighten the ministries bolts. 4, cleaning and overhauling the valve. Second, the pump repair 1, including minor repair content. 2, overhaul mechanical seal, repair and replacement parts. 3, disintegration, check the parts wear, corrosion and erosion, to be repaired or replaced. 4, check the shaft wear, corrosion and straightness, repair or replacement. 5, check the bearing wear, scratch the bearing, adjust the clearance, and replacement of bearings. 6, check and adjust the impeller seal rings, bushings, glands, shaft seals and other parts of the gap. 7, check the static balance of the impeller and rotor balancing. 8, check, clean and repair the motor. Third, the overhaul of the pump 1, including the repair content. 2, replace the impeller. 3, replace the pump shaft. 4, pump thickness, identification, make the necessary repairs. 5, measure and adjust the level of the pump body, rust corrosion. Further Reading: pump valve pipe fittings Exhibition Water Expo Xiamen exhibition of marine equipment Internet + Forum Yiwu Fair 2016 exhibition mold top ten brands of the Internet information industry (Xiamen) Technology Co., Ltd. Author: Asian pumps Network Editor: Yao Xiaoxia (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)
Push Button Hand Shower
The utility model discloses a Kitchen Shower head that is convenient to switch the water outlet mode, has a compact structure, and is easy to use, and a kitchen faucet using the kitchen shower head. , The shower head is provided with a water separator, and the water separator is provided with an annular flow channel and an inner flow channel respectively connected to the spray water outlet body and the V-shaped water outlet body, and the lower end of the outer wall of the water separator is upwardly circular A plurality of water inlet holes connected to the annular flow channel are provided, and a first sealing ring is provided on the lower side of the water inlet hole; the water outlet end of the shower body is connected with a converter, and the converter is provided with a communicating In the water diversion cavity at the water outlet end of the shower body, the lower end of the water diversion device is installed in the water diversion cavity and can move up and down, and the upper end of the inner wall of the water diversion cavity is provided with a convex ring matching the first sealing ring, so The bottom surface of the water diversion cavity is provided with a sealing gasket that can seal the inner flow channel.
Waterfall Shower Head,Overhead Shower Head,Push Button Hand Shower,Brushed Nickel Sink Faucet
Yuyao Zelin Sanitary Ware Co., Ltd , https://www.kitchen-sinkfaucet.com