Zhuzhou Diamond launches BMR03 series ball end mill

The BMR03 series ball-end milling cutters from Zhuzhou Diamond Cutting Tools Co., Ltd. adopt large axial mounting angles, plus specially optimized anti-vibration insert groove design and smooth chip-type chip flute design. High-feed cutting with Fz=0.6mm/z or higher, low cutting vibration, stable cutting and high machining efficiency. The inner blade has an over-center design, which effectively reduces the residual amount of the surface to be machined, and the surface quality of the workpiece is significantly improved. At the same time, the direct cutting of the drilling method can be realized, the machining programming is more flexible and convenient, and the feeding time is saved, greatly improving the overall Processing efficiency. The tool body is made of special heat-resistant alloy steel, which greatly improves the vibration resistance and service life of the tool. The blade has a unique tool structure design, and the blade positioning surface is precisely ground, which can fully ensure the cutting edge shape and the installation and positioning accuracy of the blade, greatly improve the processing precision of the workpiece and reduce the surface roughness.

Grips Clips And Clamps

A wire rope clamp (sometimes called a clip) is used to secure the loose end of the loop back to the wire rope. It usually consists of a U-bolt, a forged saddle, and two nuts. Two layers of wire rope are placed on the U-bolts. Then slide the saddle over the rope and attach to the bolts (the saddle includes two holes for the U-bolts). Nuts hold the unit in place. The wire rope is usually terminated using two or more clips depending on the diameter. A 2" (50.8 mm) diameter rope may require as many as eight.
There is an old saying: "A dead horse is without a saddle". This means that when installing the clips, the saddle portion of the assembly should be placed on the load bearing or "live" side of the cable, not the non-load bearing or "live" side of the cable. The "no power" side. According to U.S. Navy Manual S9086-UU-STM-010 Chapter 613R3, Wire and Fiber Ropes and Slings, "This is to protect the live or pressure-bearing end of the rope from pinching and damage. The flat bearing housing and body (saddle-shaped ) extension claws are designed to protect the rope and remain on the live end at all times."[18]

The U.S. Navy and most regulatory agencies do not recommend using such clips as permanent terminals unless regularly inspected and retightened. Encyclopedia website: ewikizh.top

Wire Rope Clips,Wire Rope Clamp,Grips Clips And Clamps,Stainless Steel Wire Clips

Jiangsu Hongze Stainless Steel Wire Rope Co., Ltd , https://www.hzrope.com