Protection of NSK bearings on the pump

Home>Bearing knowledge> Protection of NSK bearings on water pump
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Protection of NSK bearings on the pump

Source: Bearing network time: 2018-05-13

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Many of the bearings are the same protection; but each job is different; it also has different protection. Today I will analyze the protection of the NSK bearing on the pump.
(1) The pump that is newly put into use; usually it needs to replace the smooth grease (oil) after 100 hours of operation; it will be replaced once every 500 hours in the future.
(2) Select smooth bearing with smooth grease; after 1500 hours of operation; replace the smooth grease; the amount of oil added may not be too much or too little; too much or too little smooth grease will cause the bearing to heat; the amount of fuel is usually grasped 1/2 to 2/3 of the bearing chamber volume is appropriate.
(3) Regarding the selection of smooth oil smooth bearings; the amount of oil should be added to the regular orientation.
(4) Containers containing smooth oil or smooth grease should be clean; usually should be sealed; there should be no dust, iron filings, etc.; avoid damage to the bearings.
(5) The motor bearing usually uses sodium-based smooth grease; this smooth grease is characterized by high temperature (125 ° C); but it is easy to dissolve in water; therefore it can not be used for the smoothness of water pump bearings.

Recommend to friends comments close window

Bearing related knowledge
The use of CJ composite bearing bushings analyzes the normal operation of the rolling bearing and the common faults. The utilization rate of the koyo bearing and the replacement of the smoothing agent. The shaft bearing rigidity is required for the bearing-like appearance. The device and protection of the rolling mill bearing (3)


This article links to http://
Please indicate China Bearing Network http://

Previous:Revision Tips for Closing Axial Holes Next: Common Terminology Definitions for Rolling Bearing Dimensions

Intergrated Led Emergency Modules

The Intergrated Led Emergency Modules is match the compact LED fittings to improve the emergency function. Normally it is workable for small wattage from 3-60W LED panels, downlights, led tubes, tri-proof ceilings. Full power output or half power emergency output is optional. Customized emergency lighting time is available. Automatic lighting up when main power failures. Widely using for home, parking lot, office, building, warehouse, school, hospital, workshop etc.

Emergency Light Module,Emergency Led Flasher Module,Led Emergency Modules,Intergrated Led,led light with emergency battery

Foshan Nai An Lighting Electric Co.,ltd , https://www.naipsled.com