Vertical pipe pump failure mechanical seal situation, how to replace it? Now for everyone to introduce vertical pipe pump replacement failure mechanical seal method. Vertical pipe pump replacement failure mechanical seal (1) ready to place pump parts table (ground) and disassembly tools, do not arbitrarily put arbitrary use, so as not to damage the pump parts. (2) Check that the motor is under inspection before demolition; unscrew the fuel filler screw and suck the lubricant in the seal holder with straw. (3) Disassemble the split coupling: Unscrew the fixed hexagon socket head cap screw and gently pull half of the coupling shaft off the shaft (take care not to fall off). Unscrew the bolt and stopper of the pump shaft with a wrench, let the impeller slowly sink to the pump body, remove the other coupling and take off the pump shaft. (4) Disassembly sealing seat: Unscrew the sealing seat compression nut, gently remove the sealing seat (Note: do not break the seat rubber seal) and clean. (5) Disassembly and cleaning of the bearing seat: After the bearing seat is loosened down gently, lift the bearing seat with the removal bolt and lift it upwards along the axis of the pump. Remove the bearings and seat with jet fuel and dry before installation Paint a little on the 20th machine oil lubrication protection. (6) Disassembly Mechanical Seal: Grasp the seal spring and lift up the pump shaft to remove it. (7) mechanical seal assembly: static and dynamic mirror coated with a layer of clean No. 20 oil; guide bearing seat cast grease, gently positioning the stationary ring into the guide chock; then on the pump shaft Put on the lubricating oil, put the moving ring part of the mechanical seal gently into the pump shaft, gently push the sealing ring by hand to be retractable (note that the anti-rotation part of the moving and stationary ring parts should be assembled in place). (8) mounted sealing seat: sealing seat installed on the first rubber seal, seal seat and then into the pump cover and pressed on the bearing, tighten the nut. (9) Install the coupling: Install the retaining ring on the motor shaft first, install half the coupling, install the stopper in the shaft end of the pump and the coupling groove, and tighten the bolt with the wrench (lift the shaft 3 ~ 5 mm and provide mechanical seal prestress); reassemble the other half of the coupling Screw on the hexagon socket screws must be tightened. Correct installation of the coupling inspection requirements: split the upper and lower coupling evenly spaced gap; (10) according to the use of key test run to check the replacement of mechanical seal is correct, the pump is operating normally. Extended reading: Top ten brands of motor China Construction Water Exhibition Pump manufacturers ranked ptc exhibition industry Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: He Daohui (QQ / WeChat:) http://beng.liuti.cn/ (service Hotline:)
Exposed Shower Valve
Exposed Shower Valve is the simplest shower faucet. Single lever independently operate, automatic mixed cartridge design. Durable ceramic cartridge can guarantee 500,000 cycles no leaking. The thickness of electro plating reaches to 8 to 12 microns. The surface remains bright and durable even after passed 48 hours spray salt testing.
Exposed Shower Valve,Hand Shower Faucet,Hand Held Shower Heads,Hand Shower,Shower Faucet
SHENZHEN KING OF SUN INDUSTRY CO.,LTD , https://www.handybasinfaucet.com