Glass door stickers can effectively prevent UV rays, heat insulation, glaring glare, UV protection, and enhance visual effects, so they are widely used in various types of glass. Then, what are the tips for glass doors? What are the precautions for glass door stickers? Next, let Xiaobian explain it to everyone!
What are the tips of glass door stickers?
1. What are the tips for glass doors? Before the film is affixed, the size of the window must be measured. Therefore, we must prepare some related tools, such as: utility knife, scraper, ruler, watering can, etc. Look for gaps in these tools. When measuring the size of the window, measure from the same side of the window.
2. What are the tips for sticking the glass door? After the size of the film is good, the film must be cut. Before the film is cut, a soft cloth or a small blanket should be prepared so that the cut film will not scratch the floor. When cutting the film, it should be cut according to its centerline, and its size should be 5-8mm smaller than the glass size. This is convenient for the film.
3. What are the tips for sticking the glass door? Before cleaning the film, clean the glass to ensure that the glass is free of swarf and sand. Otherwise it will affect the film effect.
4. What are the tips for glass doors? At this time, the film must be applied. The film has two layers, which are the protective film and the film. Before the film is applied, a lubricant is sprayed to reduce the adhesiveness of the adhesive layer. After that, the protective film may be peeled while the film is being applied. After that, the film should be fixed and the air bubbles should be driven out from both sides. The force should be light so as not to scratch the film.
5. What are the tips for sticking the glass door? The last step is to scrape the film to catch the water, but also use a small towel to dry the scraped water, and then trim the corners without a good place, and then remove the protective film, glass The door is finished. After the film is finished, spray some detergent, wipe the residue, and wipe it with a clean rag so that the glass will be smooth and bright.
What are the precautions for glass door stickers?
1. When cutting membranes, everyone must pay attention to the membrane area should be slightly larger than the glass 1cm.
2. In order to ensure that the film does not have bubbles, in the film, use the cross buckle to position, pay attention to the principle of the first two sides after the middle of the wipe, wipe strength should be light, do not scratch the film.
3. Before scraping the film, be sure to check the integrity of the tool. The wiper blade must be flat, smooth, and free of nicks so that the film will not be scratched.
4. It must be remembered that after the glass door is attached, spray some detergent and wipe the glass with a clean rag. This is to ensure that the glass is smooth and bright and there is no residue.
Article summary: The above content is what Xiaobian has for glass door stickers and glass door stickers, what are the explanations, glass film is a technical activity, everyone in the film, be careful, avoid bubbles, avoid the wipe At the time, the film was scratched.
Fulcrum Mini Electric Hoist,Mini Electric Wire Rope Hoist,Mini Electric Rope Hoist,Mini Electric Cable Hoist
Guangdong Gongyou Lift Slings Machinery CO.,LTD , https://www.workmateslift.com