Business: Network Camera Video Conferencing Camera Monitor
first step
Take out the bracket and prepare tools and parts: Plug, Screw, screwdriver, hammer, electric drill, and other necessary tools; check the size of the plug and tapping screws according to the pre-determined mounting position; try the bracket screws and Whether the screw base of the camera base is appropriate, whether the pre-embedded pipeline interface is handled well, and whether the test cable is unblocked, and then enter the installation procedure after being ready.
Second step
Take out the camera and lens, according to the pre-determined camera lens model and specifications, carefully install the lens (infrared camera and integrated camera does not need to install the lens), be careful not to touch the lens and CCD (marked part of the figure), confirm the fixed After firm, turn on the power, connect the host or use a monitor, small TV, etc. to adjust the aperture.
third step
Take out tools such as brackets, plugs, screws, screwdrivers, hammers, drills, etc., and install the brackets in a predetermined position. After the inspection is firm, install the camera in the appointed direction; (Before installing the bracket, check the power in the place of installation to obtain a more reasonable monitoring effect.)
the fourth step
If there is a lot of dust in the outdoors or in the room, install the camera shroud. After the second step, install the shroud directly from here.
1. Open the shield cover and tailgate;
2. Pull out the fixed metal plate and fix the camera;
3, the power adapter into the shield;
4. Reset the upper cover plate and the rear baffle, straighten the cable, fix it, and install it on the bracket.
the fifth step
Insert the BNC plug of the soldered video cable into the socket of the video cable (use the two notches of the plug to align the two fixed posts of the video socket of the camera and turn it clockwise after inserting it). Make sure that the BNC connector is securely attached and in good contact.
Step 6
Insert the power adapter's power output plug into the monitoring camera's power socket and confirm the firmness (note the camera's power requirement: Normal general gun camera uses 500-800mA12V power supply, infrared camera uses 1000-2000mA12V power supply, please refer to the product instructions to select suitable The product).
Step 7
Connect the other end of the cable to the video input port of the control panel or monitor (television) in the same way to ensure firm and good contact. (If you use back-end control devices such as picture splitters and video distributors, please refer to the specific product wiring method)
Step 8
Switch on the monitoring host and camera power, adjust the camera angle to a predetermined range through the monitor, and adjust the focal length and sharpness of the camera lens to enter the recording equipment and other control equipment adjustment process.
The square nut is one of the welding nuts. The welding method is believed to be known to all. It is to use high temperature to melt some metal and weld it between the two products to play a fastening role. The fastening effect of this connection will be very good and will not be easy to loosen. It can also be used with bolts. Square nuts are mainly used in electric power engineering, road traffic, home building materials and other industries.
Square Nut,Square Nut Bolt,Square Weld Nut,Square Nuts And Bolts
Jiangsu Jiajie Special Screw Co., Ltd , https://www.jiajienuts.com