The common problems encountered by the blade:
.1 The blade is beating during operation;
4.1.1 Check whether the blade is installed properly.
4.1.2 Check if there is any debris on the working surface of the cutting machine.
4.1.3 Check the clearance between the inner diameter and the rotating shaft.
2 blade crack;
4.2.1 Before Use: Hook the blade with your finger and tap lightly with a wooden hammer to hear the sound.
4.2.2 After use: Whether the hard surface is stored on the mounting surface during installation can cause cracking of the blade.
4.2.3 In addition to the above two conditions, whether there is a problem with the man-made breakage or the blade itself.
3 blade has a gap;
4.3.1 The cutting machine did not perform idle operation for 5 minutes and started work.
4.3.2 The diameter of the element foot is too large and can be handled by adjusting the angle of the cutting edge. The specific angle should be determined according to the diameter of the element foot.
4 elements cut continuously;
4.4.1 It is clear that the foot or part of the whole PCB element scores clearly. Check whether the PCB board thickness and material are caused by the PCB deformation during high-temperature soldering.
4.4.2 The distance between the track and the blade can be adjusted small.
4.4.3 Whether the blade is used for a long time and a small gap appears, but not worn.
.1 The blade is beating during operation;
4.1.1 Check whether the blade is installed properly.
4.1.2 Check if there is any debris on the working surface of the cutting machine.
4.1.3 Check the clearance between the inner diameter and the rotating shaft.
2 blade crack;
4.2.1 Before Use: Hook the blade with your finger and tap lightly with a wooden hammer to hear the sound.
4.2.2 After use: Whether the hard surface is stored on the mounting surface during installation can cause cracking of the blade.
4.2.3 In addition to the above two conditions, whether there is a problem with the man-made breakage or the blade itself.
3 blade has a gap;
4.3.1 The cutting machine did not perform idle operation for 5 minutes and started work.
4.3.2 The diameter of the element foot is too large and can be handled by adjusting the angle of the cutting edge. The specific angle should be determined according to the diameter of the element foot.
4 elements cut continuously;
4.4.1 It is clear that the foot or part of the whole PCB element scores clearly. Check whether the PCB board thickness and material are caused by the PCB deformation during high-temperature soldering.
4.4.2 The distance between the track and the blade can be adjusted small.
4.4.3 Whether the blade is used for a long time and a small gap appears, but not worn.
Power Station Valve,Power Station Gate Valve,Power Station Valve Types,Power Station Valves
Haogong Valve Co Ltd , https://www.haogongvalve.com